Forum

Correct use of China Diesel Motor Multi-Crop Paddy Wheat Rice Thresher 125 April 12, 2019 4:42 AM

By : huimin

The wheat thresher uses axial-flow drum threshing technology and adjustable air volume cleaning technology to clear and separate grain, gluten, gluten, and cereal grass. It has the advantages of separation, small loss, and high removal rate. The ideal machine for researching and experimenting with millet is a good helper for farmers to thresh. The millet thresher is advanced in design, compact in structure, convenient in use, high in work efficiency, and is made of high-quality structural steel, which is durable, low-priced and popular among users everywhere.
The Rice Thresher 125 has an advanced design, compact structure, and high-quality structural steel. The machine adopts axial flow drum threshing technology and adjustable air volume cleaning technology to clear and separate grain, gluten, gluten, and cereal grass. It has the advantages of separation, small loss, and high removal rate. A good helper.
1. Carefully and carefully repaired before use. Before the wheat harvest, the thresher should be carefully inspected and repaired in advance to see if the bolts are loose, the rods are intact, and the transmission parts are in trouble. Find out the unsafe factors and eliminate them. Do not let the threshing machine run "ill". For the power used, whether it is a diesel engine or an electric motor, it should be tested in advance to ensure that it is safe.
2. Common intentions and reasons for thresher.
1, threshing is not clean: common reasons are uneven feeding, large grain moisture, excessive threshing gap, low drum speed, etc.;
2, the separation is unclear: common reasons are insufficient air volume or wind direction, the threshing machine screen hole damage or excessive gap, the grain is too wet equation logic; visitors are chic into the grain uneven, too dry and wet;
3, the drum is blocked: the reason is that the grain is too wet and the feed amount is too large, the rotation speed of the drum is too low, the winding of the drum tooth stalk causes the winding, the power is insufficient or the voltage is too low;
4, grain is broken: the reason is that the threshing gap is too small, the drum rotation speed is too high, the feeding grain is uneven, too dry and too wet;
5. The drum has noise: the stud bolt is loose, the concave plate is deformed, and the threshing gap is small.
 


To post a comment please register or sign in